How Can We Help?
Search for answers or browse our help center.
-
Hill DT
- 24VDC Power Distribution
- Add cable to slow cervical tilt
- Add visible markers
- Adding a FR 30-21B cervical mount bracket
- Adjust rollers instructions
- Applying grease to the cervical bolts
- Cervical Return Spring
- Cervical springs
- Check preload on lumbar
- Detach from actuator to lumbar
- Enlarge the holes so that shoulder bolts do not contact
- Flex Restraint Parts
- Harness position demonstrated
- How to access the actuator
- How to Align the Cervical Actuator
- How to Disconnect the Air Cylinder on a Distraction Table
- How to Replace the Flexi Strap Bracket on a Hill DT
- How to Replace the Power Supply
- How to Tighten the Tablet Swivel
- Lubricate lumbar actuator rod
- Lubricating points
- Lumbar Tilt Actuator Replacement
- Patient Stop Switch
- Pelvic Tilt Rest Tab
- Power supply and tablet cord
- Relay Board, Link Controller
- Remove Bolts for Roller
- Remove or change cushions
- Repair distraction actuator
- Replace a Linear Bearing
- Replace Cervical Actuator
- Replace Cervical Sensor Harness
- Replace Cervical Tilt Actuator
- Replace Flexi Straps Only
- Replace On/Off Circuit Breaker
- Replace Plunger and Roll Pin
- Replace the Belt
- Replace the Flexi Strap
- Replace the Flexistrap
- Replace the lumbar distraction actuator
- Replace the Lumbar Load Sensor
- Replace the Rods and Bushings on Hill DT
- Replace the Xenus Drive
- Replacing cervical actuator rod, spring and rivet
- Review Lumbar Distraction Assembly
- Securing the receiver tube in the cervical cushion
- Shoulder bolt alignment
- Tablet power supply
- Troubleshooting no power
- Troubleshooting the actuator rod
- Show all articles (35) Collapse Articles
Print
Relay Board, Link Controller
