Adding a Second Pressure Pedal

INS-174B AIR FLEX- ADDING A SECOND PRESSURE PEDAL

Parts List:

Corded foot pedal (“Pressure”) w/connectors – 1

3 Pigtail jumpers, black, white, & red w/connectors – 1

Wire ties – 4

Wire tie pads – 2

Cord restraint – 1

Ground Screw – 1

1. Elevate the table to its highest point.
2. Unplug the table.
3. Remove the screws holding the inside skirt to the base. Remove the inside skirt.
4. CONNECT THE PEDAL – Put the black cord restraint at the end of the pedal cord insulation and insert the cord through the hole in the metal strip of the base. Secure it in the hole with the black cord restraint. Use pliers to squeeze the restraint tight enough for insertion.
5. JUMPERS – Disconnect the RED wire of the original pressure pedal and connect each red wire from both pedals to the jumper. Insert the jumper where the original pedal was connected . Connect the BLACK & WHITE wires in the same way.
   • The GREEN lead of the new pedal can be attached directly to the base by drilling an 1/8″ hole and secure the wire with the enclosed screw.
6. Plug the table in and test both pedals.
7. Secure loose wires to the inside of the base with wire ties.
8. NOTCH THE SKIRT- Note the size of the notch in the skirt where the power cord exits the base
   • Mark the skirt with a pencil for a notch at the second location similar to the notch for the other pedal.
   • Use diagonal cutters or a hack saw to cut from the bottom edge along the two lines. Tip – After you make the parallel cuts, use a utility knife to score the top of the tab and than bend it back & forth with pliers until it breaks off.

9. Replace the skirting.