Replace Board in Control Box

Board in Control Box

IMPORTANT:

The button layouts will vary. The mounting information is the same for all boards. The version of the board is identified in the corner. The control box on the primary side of the table must have an “A ” board (may also be blank). The second box has a “B” board.

1. Unplug the table.
2. The front panel of the control box can be accessed by removing the four corner screws.
3. The new board w ill com e with mount angles already attached. provided to remove the two screws on the front of the button panel to release the original.

<– Two middle screws to release circuit board

1. The communication cable disconnects from the board the same as a phone cord. Press the tab in on the side of the connector as you pull it.
2. Hold the new board next to the original and pull one connector at a time from the original board and push it onto the same location of the new board.

Attach the board to the panel and the panel to the box. The picture below shows the board orientation.